AC 220V 100W Laser Power Supply For CO2 Laser Engraver Cutter Machine MYJG-100W
- List PriceUS$239.86piece
- Sale PriceUS$167.40piece
- ShippingFree Shipping
Input Voltage: AC220V
AC frequency: 47 - 440HZ
Max Input power: 440W
Max Input current: 3A
Max output voltage: DC35KV
Max output current: DC28mA
Environment: Operating temperature: (-10-40) degree Celsius, Relative humidity: ≤90%
Cooling: Forced air cooling (fan cooling)
Sculpture and cut acrylic,fabric,double color sheet and rubber etc
To 80W laser tube manufactured by various factories
1.Laser Tube connection: (Refer to Power supply and laser Device's connection Diagram) High voltage terminal of HY-T60 power supply should be connected to the positive pole of CO2 laser device. Current circuit of the power supply shall be connected to negative pole (laser output terminal) of laser device, through an ampere meter or directly.
2.Connection of control signal( Refer to Power supply and control board's connection Diagram) The control signal shall be reliably connected to control terminal of the power supply HY-T60,after connecting the DAC output signal and TTL signal of external computer with the power supply, the laser device shall work as expected. If the laser lamp can not work properly, should check the control signal whether correct or not(include check the voltage specification and logic),if use PWM control as power control,make sure f≥20KHz,Amplitude (peak value) ≤5V,Check and protection switch WP connection is correct at same time.
3.Voltage of power input: HY-T60's power input of the power supply shall be 220VAC/50Hz.
4. Others: A group of protection switches are also reserved for detection of water switch, fan switch,open-enclosure protection and so on.
- Quick response speed and effect,high performance
- Large cutting power
- Easy control
- Output open circuit protection
- TTL signal indication, water through signal indication
- Laser output indication
1 x Laser Power Supply